Focused arrival windows
Useful updates and clear arrival timing.
A new roof in Houston is a system, not a layer of shingles. Roof installation in Houston, TX means stripping the old roof to the deck, replacing soft sheathing, and installing underlayment, flashing, drip edge, and ventilation that hold up to 95-degree summers, spring hail, and hurricane-season wind. Start with a roof inspection and a written scope, then decide with the full picture in front of you.
Useful updates and clear arrival timing.
Review the approach and price before deciding.
Equipped vehicles and respectful cleanup.
Neighbors serving neighbors with follow-through.
Every install covers the full system, not just the top layer. Here is what is part of the job, and what gets priced separately if your roof needs it.
We remove all old roofing layers down to the sheathing so soft spots and rot can be seen and replaced. Houston's adopted code limits a roof to two layers of covering, so a roof already carrying two layers is a tear-off, not a layover.
Sheathing that is soft, delaminated, or rotted is photographed and replaced before anything goes back on. A new roof over a bad deck is money wasted.
Synthetic underlayment goes across the whole field, with a self-adhering membrane at valleys, eaves, and around penetrations, where wind-driven rain finds its way in.
Chimney flashing, vent flashing, and drip edge are replaced, not reused. Old flashing is where most Houston leaks start.
Ridge vent paired with soffit intake, so the attic can breathe. Houston attics run 140 to 160 degrees without it, and that heat ages shingles from underneath.
A re-roof inside the city needs a City of Houston Residential Roofing Permit, and the permit and inspection are part of the written scope.
Tell us what you are seeing. We will talk through the next step, what an inspection covers, and what a written scope looks like.
Roof installation in Houston is the full tear-off and rebuild of your roof system: removing old shingles or panels, replacing rotten decking, installing underlayment and flashing, then laying the new roof with new drip edge and balanced ventilation.
Houston roofs take a beating most of the country never sees: summer heat and UV that bake shingles brittle, hail from spring storms, and hurricane-season wind. Architectural shingles last roughly 18 to 25 years here, against about 30 years nationally, because heat, UV, and humidity wear the binder down. If your roof is 15-plus years old, or an adjuster has already flagged hail damage, a new roof is usually cheaper than three more years of patch repairs. Angi Houston, updated 1 August 2026: a full replacement averages $9,752, most projects run $6,712–$13,123, at $4–$11 per sq ft of roof surface. These are published market ranges, not this business’s prices. Your price depends on your roof’s size, pitch, deck condition, and material, and is set out in a written scope after an inspection.
The permit matters too. A City of Houston Residential Roofing Permit is required for a re-roof or overlay inside the city — plan review and inspection, a $33.56 admin fee, about 10 business days, valid 6 months. Roof covering of 100 sq ft or less in aggregate is exempt. In unincorporated Harris County there is no residential roofing permit. And the licence question matters more: Texas has no state roofing licence. The bill that would have created one, HB 3344, died on 8 May 2025, and Houston has only voluntary contractor registration. Ask any roofer what that means for your job — and get the answer in writing.

We walk the roof, check the deck from the attic where access allows, and photograph what we find. You get a written scope with the material, the ventilation plan, and the work included.
Materials are ordered and the City of Houston permit is applied for. The permit takes about 10 business days, so the schedule is set around it, not promised around it.
Crews strip the old roof to the deck, sweep the yard with a magnet, and replace soft sheathing. Deck repair is photographed and priced before it is done.
Underlayment, membrane at valleys and eaves, drip edge, flashing, and the new roof go down in sequence. The site is cleaned each evening.
We walk the roof and the yard with you, hand over the photos of the deck and flashing details, and confirm the permit inspection.

Drives fasteners to the correct depth and pattern for the roof system being installed.
Strip old shingles and lift flashing without tearing up the deck underneath.
Checks the deck and attic for hidden moisture before the new roof goes on.
Keep courses straight and cut clean edges at valleys and rake lines.
Picks up nails and staples from the yard and driveway after tear-off. We run it before we leave.
Safe access and staging so crews can work the whole roof plane, not just the edges.
Seals flashing joints and penetrations as part of the install, not as an afterthought.
Every cut, valley, and flashing bend is measured to the roof in front of us.
Landscaping and the driveway are covered before tear-off starts.
Photos of the deck, flashing, and finished roof go into your file, and help if an insurance claim follows.

We inspect, confirm the shingles are at end of life, and install a new architectural shingle system with new underlayment and flashing. The homeowner stops paying for repeat repairs.
We document the damage, strip to the deck, and install a new roof with a fastener pattern suited to the wind exposure. The photos go into the file for the insurance claim.
We strip to the deck, replace rotten sheathing, and install a new system with ridge vent and new drip edge. The roof is lighter, ventilated, and code-correct.
Houston roofs face a specific set of conditions: UV that bakes shingles, spring hail, hurricane-season wind, and humidity that finds every flashing gap. Building stock matters too. A 1920s bungalow in the Heights may have skip sheathing and several old layers, while a 2015 build in Cypress has newer decking but often poor attic ventilation. We scope each roof to the house, not to a template. If you are comparing installers, ask whether they pull the permit and whether they install new flashing. Call (936) 873-7200 for a written scope.
Older bungalows often have skip sheathing and several shingle layers. We strip to the deck and replace soft sheathing before installing.
Hurricane-season wind exposure is higher near the bay. We install with a fastener pattern suited to the exposure and document the work.
Low-slope ranch roofs shed water slowly and are vulnerable to wind-driven rain under the shingle edge. Flashing and underlayment matter most here.
Newer builds often have ventilation issues. We balance intake and exhaust during the install to cut attic heat.
Shingles age faster in Houston than in cooler climates. We confirm attic ventilation during the install to extend roof life.
We document storm damage with photos so the insurance claim matches what the roof actually shows.
We install membrane at valleys and eaves and replace all flashing to keep water out during Houston downpours.
A 1940s bungalow with three layers of shingles, soft decking over the porch, and a ceiling stain in the hallway. The homeowner had patched the same leak twice.
We stripped to the deck, replaced the soft sheathing, and installed a new architectural shingle system with new flashing and ridge vent. The leak stopped.
Maintenance: A yearly check of gutters and valleys, and an inspection after any hail event, keeps small problems small.
A 1990s home with wind-lifted shingles after a tropical storm. The homeowner wanted a roof that would hold in the next one.
We installed a new roof with a fastener pattern suited to the wind exposure and photographed the deck and flashing for the insurance file.
Maintenance: An inspection before hurricane season, and a prompt look after any tropical storm, is the routine that protects a new roof.
A 1960s ranch with a low-slope shingle roof, granule loss, and water tracking under the shingle edge in wind-driven rain.
We installed a new system with membrane at the eaves and valleys and new flashing throughout, so wind-driven rain stays outside.
Maintenance: Keep valleys and gutters clear. On a low-slope roof, debris holds water against the shingles.
Most Houston roof problems trace back to an aging system, storm damage, or a previous install done wrong. Here is what a full install fixes.
A stain means water is already inside the attic and insulation. We trace the leak to the source, not just the stain. Often it is chimney flashing or a vent boot. If the roof is at end of life, a new system with new flashing stops the cycle.
Hail bruises shingles and knocks granules loose. Curling shingles let water under the layers, and the damage spreads with each storm. We document hail damage for your insurance claim and install a new roof when repair no longer holds.
Water backing up under the shingles rots the fascia and soffit. Left alone, it reaches the deck and the wall framing. We replace rotten fascia and soffit during the install and check that water moves away from the house.
A hot attic shortens shingle life from underneath and forces your AC to work harder. Houston attics can hit 140 to 160 degrees without proper ventilation. We balance ridge and soffit ventilation during the install.

Our crews install roofs across Harris County every week, from 1920s bungalows in the Heights to new builds in Cypress. Every install is photographed at the deck and flashing stages, and the permit inspection is part of the job. That is what a homeowner can actually check: the photos, the permit, and the written scope.

“From our first call with Thomas Family Roofing, it was clear they were focused on giving us a quality new roof and making the whole roofing process easy to understand.”
“I had storm damage on my roof, and after the first insurance adjuster met with another roofing company, the claim was not approved for roof repair. My niece suggested I call Johnathan, and he came out, met with a different adjuster, and helped get the roof replacement approved.”
“We contacted Thomas Family Roofing for an estimate on repairs for our metal roof in Houston. Luis came out, inspected the roof in person, and explained clearly what needed attention, including a few details about flashing and panel areas that other roofers had missed.”
Rating 4.9 out of 5 from 46 Google reviews (42 five-star, 4 four-star). A further 41 reviews are visible only as an aggregate on Google. See all reviews on Google.
Angi Houston, updated 1 August 2026: a full replacement averages $9,752, most projects run $6,712–$13,123, at $4–$11 per sq ft of roof surface. These are published market ranges, not this business’s prices. Your price depends on your roof’s size, pitch, deck condition, and material, and is set out in a written scope after an inspection.
Most single-family installs run a day or two once materials and the permit are in place. Larger homes, tile roofs, or jobs with significant deck repair take longer. The schedule is set out in the written scope before work starts, and the roof is protected each evening.
A City of Houston Residential Roofing Permit is required for a re-roof or overlay inside the city — plan review and inspection, a $33.56 admin fee, about 10 business days, valid 6 months. Roof covering of 100 sq ft or less in aggregate is exempt. In unincorporated Harris County there is no residential roofing permit.
No. Texas has no state roofing licence. HB 3344, the bill that would have created one, died on 8 May 2025, and Houston has only voluntary contractor registration. Ask any roofer what that means for your job, and get the answer in writing.
Not seeing your question? Call (936) 873-7200 and talk it through with the local team.
Ask the local teamCall (936) 873-7200 and tell us what you are seeing. We will talk through what is happening, what an inspection covers, and the next step. Or send a service request with the form and we will call you back.